Differences

This shows you the differences between two versions of the page.

--- faq:setting_up_gift_cards [2020/01/06 12:34 (4 years ago)] – [Overview] kevin
+++ faq:setting_up_gift_cards [2020/01/06 12:35 (4 years ago)] – kevin
@@ Line 7: / Line 7: @@
   * Inventory item set up
   * Label set up
+The Setup Wizard options enable the various parts of System Five. The category and inventory item set up allow the user to then start selling and redeeming gift cards. If there are pre-printed cards to be used for the gift card program, then a quantity load onto the part created is a good idea as this can be used in conjunction with Highs and Lows for reordering. If the gift card is just a normal sheet of paper run through a printer, then quantity control is not going to be needed.
 <note important>Two important things to remember when **ordering your gift card numbers**
@@ Line 12: / Line 14: @@
   - The number being used should NOT start with a 3, 4, 5 or 6 as this may cause confusion with other card types
 </note>
-The Setup Wizard options enable the various parts of System Five. The category and inventory item set up allow the user to then start selling and redeeming gift cards. If there are pre-printed cards to be used for the gift card program, then a quantity load onto the part created is a good idea as this can be used in conjunction with Highs and Lows for reordering. If the gift card is just a normal sheet of paper run through a printer, then quantity control is not going to be needed.
 The set up in this example is for printing a certificate on a regular piece of paper. If the user has some pre-printed cards, then the label design would just need to contain the transaction authorization number and new dollar values.