zebra_motorolla_symbol_ds6878
no way to compare when less than two revisions
Differences
This shows you the differences between two versions of the page.
Last revision | |||
— | zebra_motorolla_symbol_ds6878 [2018/07/05 11:14 (6 years ago)] – created swind | ||
---|---|---|---|
Line 1: | Line 1: | ||
+ | ====== Zebra / Symbol / Motorolla DS6878 2D Barcode Scanner ====== | ||
+ | |||
+ | |||
+ | [[http:// | ||
+ | |||
+ | |||
+ | {{ : | ||
+ | |||
+ | |||
+ | ===== Programming the Ctrl+B | ||
+ | |||
+ | |||
+ | {{ : | ||
+ | |||
+ | |||
+ | **Print the PDF file above and scan the barcode** | ||
+ | |||
+ | This is a single barcode scan to enable the Ctrl+B prefix otherwise known as the STX prefix. | ||
+ | |||
+ | It has been tested to work with the **DS6878** Barcode Scanner. | ||
+ | |||
+ | |||
+ | <note important> | ||
+ | |||
+ | Open a search box and type CMD. This should find the CMD.EXE. Right click on it and select run as administrator. | ||
+ | Right click the icon at the top left of the command prompt window and select Properties. | ||
+ | Make sure that "Use legacy console (requires re-launch) is checked. Click OK and close the command prompt. | ||
+ | |||
+ | </ | ||
+ | |||
+ | **Now go to System5 / Setup Wizard / Point of Sale Devices / Barcode Reader** | ||
+ | - Click on "Now Scan Barcode" | ||
+ | - Scan any Item with a barcode | ||
+ | - Click "Save Settings" | ||
+ | - Click " | ||
+ | |||
+ | {{: | ||
+ | |||
+ | |||
+ | |||
+ | ---- | ||
+ | |||
+ | Created by Steve Wind July 5 2018 | ||
zebra_motorolla_symbol_ds6878.txt · Last modified: 2021/05/11 21:56 (3 years ago) by jdayanan