pos_devices_-_opos_drivers
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
pos_devices_-_opos_drivers [2009/06/10 11:18 (15 years ago)] – nbains | pos_devices_-_opos_drivers [2023/05/10 10:46 (11 months ago)] (current) – swind | ||
---|---|---|---|
Line 1: | Line 1: | ||
+ | < | ||
+ | \\ | ||
+ | \\ | ||
====== Installing OPOS Drivers ====== | ====== Installing OPOS Drivers ====== | ||
For Point of Sale Devices that use OPOS drivers, there are two sets of drivers that must be installed.\\ | For Point of Sale Devices that use OPOS drivers, there are two sets of drivers that must be installed.\\ | ||
- | * Generic OPOS Drivers ftp:// | + | * Generic OPOS Drivers ftp:// |
* Manufactures OPOS Drivers. | * Manufactures OPOS Drivers. | ||
- | It may be nessasary | + | It may be nessesary |
\\ | \\ | ||
+ | |||
+ | |||
+ | ====== General Setup in System Five ====== | ||
+ | |||
+ | - Log into System Five | ||
+ | - Open POS Device Manager and set the " | ||
+ | - Under the OPOS Tab we will need to select the Device that is created with the mfg. OPOS drivers | ||
+ | - Under the Debug Sub-Menu we can test to make sure the device is working | ||
+ | |||
+ | \\ | ||
+ | |||
+ | |||
===== Supported OPOS Devices ===== | ===== Supported OPOS Devices ===== | ||
- | The following OPOS devices are supported. In theory all supported devices should work, but not nessasarily.\\ | + | The following OPOS devices are supported. In theory all supported devices should work, but not necessarily.\\ |
+ | |||
+ | [[https:// | ||
==== Scanners ==== | ==== Scanners ==== | ||
Line 13: | Line 30: | ||
* Metrologic MS2020 (scale/ | * Metrologic MS2020 (scale/ | ||
- | |||
- | ==Metrologic MS2320 Config== | ||
- | * Install Metrologic manufacturer drivers ftp:// | ||
- | * Verify Windward OPOS drivers are installed ftp:// | ||
- | * Install MetrOPOS Admin tool from ftp:// | ||
Line 23: | Line 35: | ||
Tested devices | Tested devices | ||
* Metrologic MS2020 | * Metrologic MS2020 | ||
+ | |||
+ | ==Metrologic MS2320 Config== | ||
+ | * Install Metrologic manufacturer drivers ftp:// | ||
+ | * Verify Windward OPOS drivers are installed ftp:// | ||
+ | * Install MetrOPOS Admin tool from ftp:// | ||
+ | * In the Modify Profile screen, choose MS2020 model, RS232 Port, COM 1,\\ Dual Cable (If more then 1), Device as Scale and Display Yes.\\ | ||
+ | |||
+ | * Select Detailed Test tab and click "Open, Enable, Claim" and then "Read Weight" | ||
+ | * Output = If Timed Out (1000 milliseconds) error then nothing on scale | ||
+ | |||
+ | |||
==== Pole Display ==== | ==== Pole Display ==== | ||
Tested devices | Tested devices |
pos_devices_-_opos_drivers.1244657938.txt.gz · Last modified: 2009/06/10 11:18 (15 years ago) by nbains