User Tools

Site Tools


isc250_configuration

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
Next revision
Previous revision
isc250_configuration [2019/05/08 16:04 (5 years ago)] – [When TCPIP isn't supported by Payment processor] swindisc250_configuration [2021/05/11 12:02 (3 years ago)] (current) tanya
Line 2: Line 2:
 ==== UNDER CONSTRUCTION ==== ==== UNDER CONSTRUCTION ====
  
-[[http://wws5.com/|{{http://wws5.com/images/topxxxgif-ani.gif  |Windward Software}}]] 
  
 ====== SETUP / CONFIGURATION ====== ====== SETUP / CONFIGURATION ======
Line 13: Line 12:
  
 This is the simplest method as well because it doesn't rely on port forwarding or Remote POS Device Manager. This is the simplest method as well because it doesn't rely on port forwarding or Remote POS Device Manager.
 +The device must be end-to-end encrypted so this will not work for most.
  
 First you will need to configure the pin pad for TCPIP. To do this, refer to the following document. First you will need to configure the pin pad for TCPIP. To do this, refer to the following document.
Line 18: Line 18:
 https://www.datacapsystems.com/support-articles/how-to-change-pin-pad-interface-settings https://www.datacapsystems.com/support-articles/how-to-change-pin-pad-interface-settings
  
-Once configured, Set the pin pad type to the ISC 250 and if supported by the payment processor you can set the IP Address in the setup wizard.+Once configured, Set the pin pad type to the ISC 250 and if supported by the payment processor you can set the IP Address in the setup wizard. You will need to set the device for fixed ip in your router.
  
 Even though you will not be using a COM port to communicate with the pin pad, the DSI Client software requires one to be selected. If you do not select one you will get an error saying "Incomplete Transaction" "COM port not found in XML". Any valid COM Port can be selected. Even though you will not be using a COM port to communicate with the pin pad, the DSI Client software requires one to be selected. If you do not select one you will get an error saying "Incomplete Transaction" "COM port not found in XML". Any valid COM Port can be selected.
Line 33: Line 33:
  
    
-----+===== Configure pinpad from USB-Serial Mode ===== 
 + 
 +http://confluence.verosa.com/display/EMV/Elavon+Ingenico+ISC+250+for+USB-Serial+Mode 
  
  
isc250_configuration.1557356644.txt.gz · Last modified: 2019/05/08 16:04 (5 years ago) by swind