User Tools

Site Tools


isc250_configuration

This is an old revision of the document!


Ingenico ISC 250 ====== ==== UNDER CONSTRUCTION

Windward Software

Configuration

Configuration Over Terminal Services

Recommended setup is using TCPIP

This is the simplest method as well because it doesn't rely on port forwarding or Remote POS Device Manager.

First you will need to configure the pin pad for TCPIP. To do this, refer to the following document.

https://www.datacapsystems.com/support-articles/how-to-change-pin-pad-interface-settings

once configured, Set the pin pad type to the ISC 250 and if supported by the payment processor you can set the IP Address in the setup wizard.

Even though you will not be using a COM port to communicate with the pin pad, the DSI Client software requires one to be selected. If you do not select one you will get an error saying “Incomplete Transaction” “COM port not found in XML”. Any valid COM Port can be selected.

—-

Created by Steve Wind November 9 2018

myWindward

isc250_configuration.1541792125.txt.gz · Last modified: 2018/11/09 11:35 (5 years ago) by swind