honeywell_3800g
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
honeywell_3800g [2018/01/26 11:31 (6 years ago)] – swind | honeywell_3800g [2021/04/19 20:55 (3 years ago)] (current) – kturner | ||
---|---|---|---|
Line 1: | Line 1: | ||
+ | ====== Honeywell 3800G, 1452G and HP ElitePOS 2D Barcode Scanners ====== | ||
- | {{: | + | [[https:// |
+ | |||
+ | [[https:// | ||
{{: | {{: | ||
Line 7: | Line 10: | ||
**Print the PDF file above and scan the barcode** | **Print the PDF file above and scan the barcode** | ||
- | | + | This is a single barcode scan to enable the Ctrl+B prefix otherwise known as the STX prefix. |
- | It has been tested to work with the **3800g** as well as the **1452G** | + | |
+ | It has been tested to work with the **3800G** as well as the **1452G** | ||
+ | |||
+ | This also works with the **HP ElitePOS 2D** Barcode Scanner. | ||
+ | |||
+ | |||
+ | <note important> | ||
+ | |||
+ | Open a search box and type CMD. This should find the CMD.EXE. Right click on it and select run as administrator. | ||
+ | Right click the icon at the top left of the command prompt window and select Properties. | ||
+ | Make sure that "Use legacy console (requires relaunch) is checked. Click OK and close the command prompt. | ||
+ | |||
+ | </ | ||
**Now go to System5 / Setup Wizard / Point of Sale Devices / Barcode Reader** | **Now go to System5 / Setup Wizard / Point of Sale Devices / Barcode Reader** | ||
Line 17: | Line 32: | ||
{{: | {{: | ||
+ | |||
+ | |||
Created by Steve Wind February 19 2016 | Created by Steve Wind February 19 2016 | ||
+ | |||
+ | |||
+ | |||
+ | ====== Honeywell Voyager 1452g Alternate Configuration ====== | ||
+ | |||
+ | 1. Scan the #5 barcode (~ P R E B K 2 9 9 0 5 4 2 0 6) to program the STX on the scanner' | ||
honeywell_3800g.1516995119.txt.gz · Last modified: 2018/01/26 11:31 (6 years ago) by swind