honeywell_3800g
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revision | Next revisionBoth sides next revision | ||
honeywell_3800g [2018/01/26 11:32 (6 years ago)] – swind | honeywell_3800g [2018/01/26 11:52 (6 years ago)] – swind | ||
---|---|---|---|
Line 1: | Line 1: | ||
+ | ====== Honeywell 3800G and 1452G ====== | ||
+ | [[http:// | ||
+ | |||
+ | |||
{{: | {{: | ||
Line 9: | Line 13: | ||
This is a single barcode scan to enable the Ctrl+B prefix otherwise known as the STX prefix. | This is a single barcode scan to enable the Ctrl+B prefix otherwise known as the STX prefix. | ||
- | It has been tested to work with the **3800g** as well as the **1452G** | + | It has been tested to work with the **3800G** as well as the **1452G** |
+ | <note important> | ||
+ | |||
+ | Open a search box and type CMD. This should find the CMD.EXE. Right click on it and select run as administrator. | ||
+ | Right click the icon at the top left of the command prompt window and select Properties. | ||
+ | Make sure that "Use legacy console (requires relaunch) is checked. Click OK and close the command prompt. | ||
+ | |||
+ | </ | ||
**Now go to System5 / Setup Wizard / Point of Sale Devices / Barcode Reader** | **Now go to System5 / Setup Wizard / Point of Sale Devices / Barcode Reader** | ||
Line 19: | Line 30: | ||
{{: | {{: | ||
+ | |||
+ | |||
Created by Steve Wind February 19 2016 | Created by Steve Wind February 19 2016 | ||
honeywell_3800g.txt · Last modified: 2021/04/19 20:55 (3 years ago) by kturner