home_equinox_pinpad_setup
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revision | Last revisionBoth sides next revision | ||
home_equinox_pinpad_setup [2014/08/08 10:35 (10 years ago)] – craig | home_equinox_pinpad_setup [2014/08/08 10:40 (10 years ago)] – craig | ||
---|---|---|---|
Line 28: | Line 28: | ||
**DO NOT PLUG THE DEVICE TO THE COMPUTER UNTIL ALL DRIVERS ARE INSTALLED AND DEVICE IS CONFIGURED** | **DO NOT PLUG THE DEVICE TO THE COMPUTER UNTIL ALL DRIVERS ARE INSTALLED AND DEVICE IS CONFIGURED** | ||
- | Drivers can be downloaded from here:F:\USERS\Equinox L5300\USDebit16875.zip | + | Drivers can be downloaded from here: ftp:// |
Installing device drivers on Computer: | Installing device drivers on Computer: | ||
- | 1. installing L5000 Serial Driver (01 - L5000 SErial Driver). | + | 1. Unzip the downloaded program, Plug in the USB and allow the driver to update from the unzipped folder. |
- | a. Run Install.bat for your operating system | + | |
- | + | ||
- | 2. installing FPE Interface (02 - FPE Interface) | + | |
- | a. Run HypercomFPEInterfaceSetup.EXE **NO DO NOT INSTALL THIS** | + | |
3. Restart Computer | 3. Restart Computer | ||
- | 4. Plug the device to the computer. If both installation were successful your device should be detected and you will see a Hypercom L5xxx Terminal(COM1) on the Device manager ports. | + | 4. Plug the device to the computer. If both installation were successful your device should be detected and you will see a Hypercom L5xxx Terminal(COM5) on the Device manager ports. |
{{: | {{: | ||
- | |||
- | **Please take note : Once the device is installed corrected and plugged in, do not un-plug the device from the computer. This may assign new COM port to the device and may not function properly.** | ||
- | |||
home_equinox_pinpad_setup.txt · Last modified: 2015/01/06 16:03 (9 years ago) by cparagoso