User Tools

Site Tools


faq:using_barcode_scanners_with_windows_terminal_services

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
Next revision
Previous revision
faq:using_barcode_scanners_with_windows_terminal_services [2018/06/29 11:48 (6 years ago)] swindfaq:using_barcode_scanners_with_windows_terminal_services [2021/09/24 16:15 (3 years ago)] (current) swind
Line 1: Line 1:
 +
 +<note important>This document is also available as a FreshDesk Solution Article \\
 +</note>
 +
 +
 +
 ====== Problem ====== ====== Problem ======
 CTRL+B character (STX Prefix) is not transmitted when scanning a barcode from a client connected via Windows RDP CTRL+B character (STX Prefix) is not transmitted when scanning a barcode from a client connected via Windows RDP
Line 12: Line 18:
  
 {{faq:ts-scanner1.jpg|}} {{faq:ts-scanner1.jpg|}}
 +
  
 If you are running Windows 10 and still do not get the ^B character, you will need to run the command prompt as an administrator on the local workstation, and on the remote session, then check the properties of the command prompt. If you are running Windows 10 and still do not get the ^B character, you will need to run the command prompt as an administrator on the local workstation, and on the remote session, then check the properties of the command prompt.
Line 23: Line 30:
   * Relaunch the command prompt and scan a barcode. You should now see the ^B   * Relaunch the command prompt and scan a barcode. You should now see the ^B
  
 +--------------------------
  
 +updated by Steve Wind June 29 2018
  
  
  
  
faq/using_barcode_scanners_with_windows_terminal_services.1530298125.txt.gz · Last modified: 2018/06/29 11:48 (6 years ago) by swind