Differences

This shows you the differences between two versions of the page.

--- faq:ibc_equipment_setup [2018/02/08 17:29 (6 years ago)] – pwright
+++ faq:ibc_equipment_setup [2019/11/07 09:04 (5 years ago)] – [POS Tablet ION-TAB8-Z4UG] craig
@@ Line 1: / Line 1: @@
-{{:windward_supported_hardware_list:posx-omni-config.png?linkonly|}}====== IBC Equipment Setup for Windward Software ======
+{{:windward_supported_hardware_list:posx-omni-config.png?linkonly|}}
+====== IBC Equipment Setup for Windward Software ======
 This is an overview of how to configure POSX point of sale equipment provided by International Bar Code (IBC).
@@ Line 9: / Line 10: @@
   * 16" Cash Drawer (POSX ION-C16A-1B)
   * Barcode Scanner (ie:XI3000U or POS-X EVO 2D scanner)
 <note>Power on switch is located on right bottom of screen right near the power plug in.</note>
@@ Line 166: / Line 169: @@
 \\
+===== POS Tablet ION-TAB8-Z4UG =====
+  * Setup the Zebra embedded Scanner as instructed here. [[https://www.zebra.com/us/en/support-downloads/knowledge-articles/evm/emulating-a-com-serial-port-over-usb-using-cdc-driver.html|USB-COM]].
+  * There is no article on reverting so don't do this willy-nilly. There is a barcode to revert, but you will have to contact POS-X support to get it.
+  * This will create a Virtual USB-Serial Port in the device manager.
+  * Select this serial port in the POS Device Manger.
 ===== HP ElitePad with Retail Jacket (Beta - not currently supported) =====
   * This tablet is a W8 tablet with MSR and barcode scanner.