User Tools

Site Tools


datalogic_quickscan_2d

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
datalogic_quickscan_2d [2018/07/24 13:46]
swind
datalogic_quickscan_2d [2018/09/07 09:32] (current)
swind
Line 1: Line 1:
-====== Datalogic QuickScan (2D Models) ======+{{ :​barcodescan:​820055914_tom.pdf |}}====== Datalogic QuickScan (2D Models) ======
  
  
Line 62: Line 62:
 Once this is done, no other configurations are necessary. ​ Once this is done, no other configurations are necessary. ​
 In this configuration,​ the STX Prefix is not needed. System Five and the POS Device Manager will be monitoring that port for activity. In this configuration,​ the STX Prefix is not needed. System Five and the POS Device Manager will be monitoring that port for activity.
 +
 +
 +
 +
 +====== Removing Leading And Trailing Digits From UPC Barcodes ======
 +
 +<note important>​ Removing digits from the UPC barcodes is not recommended. However, in some very specific cases this could be done.
 +Be aware that if you do this, it will do it for all barcodes going forward, and all barcodes scanned previously with the first and last digits attached will not scan anymore.
 +So you MUST be absolutely sure that you need to do this. </​note> ​
 +
 +Print the following document and scan the highlighted 2D barcodes in the numerical order specified. ​
 +
 +{{ :​barcodescan:​820055914_tom.pdf |}}
  
  
Line 68: Line 81:
  
 Created by Steve Wind February 13 2015 Created by Steve Wind February 13 2015
 +Updated by Steve Wind and Tom Muir September 7 2018
  
 ====== ======
 [[http://​mywindward.wws5.com|{{ ​ http://​wws5.com/​support/​images/​cust_support_banner_bottom.jpg ​ |myWindward [[http://​mywindward.wws5.com|{{ ​ http://​wws5.com/​support/​images/​cust_support_banner_bottom.jpg ​ |myWindward
datalogic_quickscan_2d.1532465187.txt.gz ยท Last modified: 2018/07/24 13:46 by swind