datalogic_quickscan_2d
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
datalogic_quickscan_2d [2018/07/24 12:04 (6 years ago)] – swind | datalogic_quickscan_2d [2018/09/07 09:30 (6 years ago)] – swind | ||
---|---|---|---|
Line 1: | Line 1: | ||
- | ====== Datalogic QuickScan (2D Models) ====== | + | {{ : |
Line 59: | Line 59: | ||
Now you will need to open the POS Device Manager as administrator and set the port to the one in the Windows Device Manager (Shown in picture above). | Now you will need to open the POS Device Manager as administrator and set the port to the one in the Windows Device Manager (Shown in picture above). | ||
- | Check the Keyboard Wedge checkbox. | + | You may need to check the Keyboard Wedge checkbox |
Once this is done, no other configurations are necessary. | Once this is done, no other configurations are necessary. | ||
In this configuration, | In this configuration, | ||
+ | |||
+ | |||
+ | |||
+ | |||
+ | ====== Removing Leading And Trailing Digits From UPC Barcodes ====== | ||
+ | |||
+ | <note important> | ||
+ | Be aware that if you do this, it will do it for all barcodes going forward, and all barcodes scanned previously with the first and last digits attached will not scan anymore. | ||
+ | So you MUST be absolutely sure that you need to do this. </ | ||
+ | |||
+ | Print the following document and scan the highlighted 2D barcodes in the numerical order specified. | ||
+ | |||
+ | {{ : | ||
datalogic_quickscan_2d.txt · Last modified: 2021/12/06 15:57 (2 years ago) by swind