User Tools

Site Tools


datalogic_quickscan_2d

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
Next revision
Previous revision
Next revisionBoth sides next revision
datalogic_quickscan_2d [2016/08/26 11:11 (8 years ago)] swinddatalogic_quickscan_2d [2016/08/26 11:20 (8 years ago)] swind
Line 20: Line 20:
 ===== Programming for : General 1D and 2D Barcode Scanning Within System Five ===== ===== Programming for : General 1D and 2D Barcode Scanning Within System Five =====
  
-Simply scan the first 2D barcode on the Left marked "Windward Configuration"+Simply scan the first 2D barcode on the Left marked "Windward Configuration". Wait for all 3 sets of tones. 
 +First tone is a double beep, then a warble tone, and then an Ascending tone.
  
-If barcode scanner still is not performing correctly, scan the "Reset To Factory Defaults" barcode on the bottom, and then scan the "Windward Configuration" barcode on the Top Left.+If barcode scanner still is not performing correctly, scan the "Reset To Factory Defaults" barcode on the bottom, Wait for all three tones, and then scan the "Windward Configuration" barcode on the Top Left. Again... Wait for all 3 sets of tones. 
 +First tone is a double beep, then a warble tone, and then an Ascending tone.
  
 +These barcodes can be scanned directly off an LCD Monitor, however, if you are unable to do that, you can print it out and scan it from the printed copy.
  
 {{:barcodescan:barcodescan:qbt2400:fullsizerender2.jpg?300|}} {{:barcodescan:barcodescan:qbt2400:fullsizerender2.jpg?300|}}
datalogic_quickscan_2d.txt · Last modified: 2021/12/06 15:57 (2 years ago) by swind