datalogic_quickscan
Differences
This shows you the differences between two versions of the page.
Next revision | Previous revision | ||
datalogic_quickscan [2013/05/28 07:52 (11 years ago)] – created swind | datalogic_quickscan [2021/04/19 21:48 (3 years ago)] (current) – [Datalogic QuickScan (Not 2D Models)] kturner | ||
---|---|---|---|
Line 1: | Line 1: | ||
- | ====== Datalogic QuickScan ====== | + | ====== Datalogic QuickScan |
- | [[http://wws5.com/ | + | [[https://www.windwardsoftware.com/resources/shop-pos-hardware.html|SHOP FOR COMPATIBLE HARDWARE]] |
Line 8: | Line 8: | ||
{{barcodescan: | {{barcodescan: | ||
- | |||
====== Programming The Datalogic QuickScan ====== | ====== Programming The Datalogic QuickScan ====== | ||
- | Download and print the following PDF. | ||
- | {{ms_9540.pdf|}} | + | To program the STX prefix, download and print the following PDF. |
+ | |||
+ | {{barcodescan: | ||
+ | |||
+ | - Scan the Enter Configuration barcode. | ||
+ | - Scan the One Character Header barcode. | ||
+ | - Scan the 0 barcode from the Hex Numeric Table | ||
+ | - Scan the 2 barcode from the Hex Numeric Table | ||
+ | - Scan the Exit and Save Configuration barcode. | ||
+ | |||
+ | This MUST be done in this exact order, or you will have to start over. | ||
+ | |||
+ | If you are unable to program the scanner using the above PDF, the same information can be found in the programming manual pdf below, on pages 62 and 174. | ||
+ | |||
+ | {{barcodescan: | ||
- | - Scan the Enter/Exit Configuration Mode barcode. | ||
- | - Scan the Enable STX Prefix barcode. | ||
- | - Scan Enable CR Suffix barcode | ||
- | - Scan the Enter/Exit Configuration Mode barcode. | ||
- | Scanner should now beep 3 times if programmed correctly. | ||
Drop to a command prompt and scan a barcode (NOT one of the ones from the programming sheet) | Drop to a command prompt and scan a barcode (NOT one of the ones from the programming sheet) | ||
Line 36: | Line 43: | ||
- | Setting up your Barcode scanner in System Five is the last step. You must ensure that the device itself is properly configured with the Pre and Post amble characters that will not conflict with either System Five or the Windows (TM) Operating System. The Barcode Reader page in the Setup Wizard provides a method of using the actual device to input the configuration. | + | Setting up your Barcode scanner in System Five is the last step. You must ensure that the device itself is properly configured with the Pre amble and Post amble characters that will not conflict with either System Five or the Windows (TM) Operating System. The Barcode Reader page in the Setup Wizard provides a method of using the actual device to input the configuration. |
{{con_bar_code_reader_page.png|}} | {{con_bar_code_reader_page.png|}} | ||
Line 49: | Line 56: | ||
- | Created by Steve Wind May 8 2013 | + | Created by Steve Wind May 28 2013 |
====== | ====== | ||
[[http:// | [[http:// |
datalogic_quickscan.1369752739.txt.gz · Last modified: 2013/05/28 07:52 (11 years ago) by swind